knob approximately half way to the right. Rotate the station selector knob slowly until a station is heard. Tune this station in until the minimum amount of background noise is heard. Increase or decrease the volume to the desired level by adjusting the volume control knob. Careful tuning will result in better tone quality from all stations.

If the program being received is from a powerful local station local interference may be practically eliminated by turning the sensitivity control to the LOCAL position. You then will get the best possible reproduction of that station's program.

The sensitivity control is located on the lower, left front corner of the receiver case and when turned to the LOCAL position it decreases the sensitivity of the receiver sufficiently to greatly reduce interference from street cars, electric signs, X-Ray machines, electrical machinery, power lines, etc. It will also eliminate interference from weak stations.

When the control is turned to the DISTANCE position the receiver is allowed to operate at maximum sensitivity.

The tone control is located on the lower, right front corner of the receiver case. This control is to be adjusted at the operator's will. However, most experienced operators prefer to set it for maximum treble response when the car is operated at high speeds.

If the control head has a key knob in the center pull the knob out until it clicks into the off position and the receiver ceases to operate. If you wish to lock the receiver, pull the knob all the way out of the control unit and carry it with you.

If you are using the type of control unit which has a combination on-off switch and volume control knob turn the knob to the left until the receiver ceases to operate.

SERVICE

Should your receiver fail to operate, first check the fuse located in the fuse holder in the ammeter cable. If you wish to remove your tubes and vibrator for test purposes, their location is indicated below.

Tube Complement 2 Type 6D6 1 Type 6A7 1 Type 6B7 1 Type 6B5 1 Type 84

Any further service work on your receiver should be referred to a competent radio service station.

When at home call your local

DEALER..............................................................

AT.......................................................................

TELEPHONE.......................................................

DATE RADIO INSTALLED..................................

Principal Broadcast Stations