art of manufacturing paper hangings,

CURIOUS ARTS.

1. Water-proof gilding and silvering.—This kind of gilding, usually termed oil gilding, being the cheapest and most durable, is in general use for gilding or silvering letters on signs, labels, &c. and may be performed as follows:—Grind one ounce of white lead and two ounces of litharge, very fine, in a gill of old linseed oil, and if convenient, add nearly one-fourth of a gill of old copal varnish, and half an ounce of stone yellow; but neither of these last, are very essential ingredients. Expose this composition to the rays of the sun for a week or more in a broad open vessel, observing, however, to keep it free from dust. Then pour off the finest part, and dilute it with as much spirits of turpentine as will make it work freely with a brush or camel-hair pencil. (Oil that will answer exceedingly well for this purpose, may sometimes be collected from the top of oil paints that have been long standing, and may be used directly, without being exposed to the sun as directed above.) Whatever letters or figures you would gild, must be first drawn or painted with this sizing, the ground having been previously painted and varnished; and when the sizing is so dry as to be hard, but yet remains slightly adhesive, or sticky, lay on gold or silver leaves smoothly over the whole, pressing them down gently with a soft ball of cotton. The most convenient manner of performing this, is to lay the leaves of gold or silver, first on a piece of deer-skin or glove-leather, and cut them into pieces of a convenient size, by drawing a smooth (not sharp) edged knife over them. Then take a small block of wood, of a triangular form, about half an inch thick, and two inches in diameter, and bind a strip of fine flannel round the edges;—breathe on this, and press it gently on a piece of the leaf, which by this may be taken from the leather, and carried to any part of the sizing where it will best fit, and to which it will readily adhere: thus the sizing may be readily covered with the leaf, very little of which will be wasted. Afterward the whole may be brushed over lightly with cotton, or a soft brush, and the superfluous gold or silver will be brushed off, leaving the letters or figures entire. When the work has thus remained two or three days, it may be rubbed with a piece of silk, which will increase its metallic lustre. Note.—It is very essential that the varnish of the ground should be thoroughly dry, that it may not be adhesive in the least degree, otherwise the leaf will stick where it should not, and materially injure the work. When plain gilding is required for vanes, balls, &c. the leaves of gold or silver may be applied to the work directly from the book, without cutting or dividing them.

2. The art of burnish gilding.—Make a sizing by boiling the skins of beaver and musk rats, (which may be readily procured at a hat manufactory,) in water, till it is of sufficient strength that by cooling it will become a stiff jelly; strain the liquor while warm, and give your work one coat of it with a brush; when this is dry, add a little fine whiting to the sizing, and give the work one coat of this. Then add as much whiting as will work freely under the brush, and lay on five or six coats of this, allowing each a sufficient time to dry. Smooth the work by wetting it, and rubbing it with a piece of pumice stone, which should be previously cut and fitted to the moulding or other work that is to be gilt; afterward, when the work is dry, rub it with some fine sand paper. Then take some burnish-gold-size (which is composed of pipe-clay, plumbago, beef tallow and castile soap, but may be easily procured ready made,) and dilute it with water till it is of the consistence of very soft putty, and afterward with the above mentioned sizing till it will flow freely from a brush, and give the work three successive coats of this; when the last is dry, dip a camel-hair pencil in a mixture of equal quantities of rum and water, and with it wet a small part of the work, and immediately, while it is flowing, lay on a leaf of gold, brushing it down with a very soft, flat camel-hair brush, with which also, the leaf is usually conveyed from the book to the sizing; proceed thus till the whole is gilt, and let it dry. When the work is sufficiently dry to take a fair polish by burnishing, (which can be only ascertained by applying the burnisher to different parts of the work occasionally while it is drying,) rub over the whole carefully with a flint burnisher, or with the tooth of a wolf or dog, being fixed in a convenient handle, till the whole acquires a brilliant polish, except such parts as are required to remain in a rough-gilt state, which parts are usually flatted by a coat of thin sizing. Such are the principal rules of the art of burnish gilding; but as this business requires some variation of management, according to the state of the weather and other circumstances, it may not be expected that any person should become very expert in the art, without the advantage of some experience and practice.

3. Ornamental bronze gilding.—This is performed by means of gold or silver, reduced to an impalpable powder, called bronze. One method of preparing it, is to levigate any quantity of gold or silver leaves on a stone, with some clarified honey; dilute the honey with clear water, that the bronze may settle; pour off the water and honey, and add fresh water to the bronze, which, after being thus thoroughly washed, may be dried on paper, and is ready for use. Another method of preparing the gold bronze, is to precipitate the gold from its solution in nitro-muriatic acid, (see 5,) by adding sulphate of iron to the solution;—then washing it, as directed above. But in general it will be found much cheaper to buy the bronze ready prepared. The ground for this work must be varnished with a mixture of copal varnish, with an equal quantity of old linseed oil; and whatever figures are to be formed in bronzing, must be represented by holes cut through pieces of paper. Lay these patterns on the work, when the varnish is so dry as to be but slightly adhesive, but not press them down any more than is requisite to keep the paper in its place. Then take a piece of soft glove-leather, moisten it a little by breathing on it, and dip it in some dry bronze, and apply it to the figures, beginning at the edges;—tap the figure gently with the leather, and the bronze will stick to the varnish according to the pattern. Thus any figure may be produced in a variety of shades, by applying the bronze more freely to some parts of the work than to others. If some internal parts of the figures require to be more distinct than others, they may be wrought by their peculiar patterns, or may be edged with dark coloured paint. In some work it may be well to extend the varnish no farther than the intended figures, in which case, any projecting or branching parts of the figures, may be drawn with a camel-hair pencil, and the patterns may