sure that these studs do not enter the case far enough to cause damage to the receiver parts.

Install the receiver, using the drilling template as a spacer between the dash and the receiver case. Install the two shakeproof washers over the chassis mounting studs. Then tighten the mounting nuts to insure that the receiver case shall be thoroughly grounded to the dash.

Attach the black antenna lead to the car antenna and plug the connector on the antenna lead into the receiver chassis as shown in the Installation Diagrams. Ground the pigtail of the antenna lead shield to a convenient body bolt. Keep antenna lead out of engine compartment to avoid possibility of ignition interference being picked up by the lead-in.

See Instructions in speaker package.

See Instructions in remote control package.

CONTROL UNIT ADJUSTMENT

The volume control and station selector shafts are AUTOMATICALLY adjusted as follows:

1. Insert control cables in their respective bushings on the case (volume control is upper bushing when receiver is installed in the car), until they seat themselves and then tighten the set screws.

2. Turn the station selector knob to the right (clockwise) until it stops—then turn the knob counter-clockwise until it stops. The dial is now logged.

3. Turn the volume control knob clockwise until the knob turns hard. The volume control is now on full.

Connect the ammeter condenser to the spring clip at the end of the wire containing the fuse holder by means of the self-threading screw on the side of the spring clip. Ground the other terminal of the condenser at any convenient point.

Install the generator condenser on the generator side of the generator cut-out as shown in the Diagram of Connections. DO NOT connect the flexible lead to the field terminal of the generator.

Remove the center distributor lead and insert the distributor suppressor in its place. Then plug the distributor lead into the suppressor.

Turn the receiver on.

Tune-in a radio station which logs between 55 and 65 on the dial and gives the radio a signal BARELY AUDIBLE in the speaker WITH the VOLUME control FULL ON. A small snap button cap is located in the end of the receiver case beside the antenna lead connection. Remove the snap button cap by prying with a small screw driver.

By means of a small screw driver inserted in the hole which was covered by the small cap, adjust the Delco Syncro-Tuning condenser unit for maximum output in the speaker. Remaining on same station, readjust station selector for maximum volume and readjust the Delco Syncro-Tuning Condenser unit for maximum output. No further adjustment of this unit will be necessary as the receiver is now adjusted for best operation with your car antenna. Replace the snap button cap.

OPERATION

Some control units have a small knob located below the center of the dial. If your receiver is equipped with this type of control push this small knob in as far as it will go. Other control units have a combination on-off switch and volume control knob. To turn on this type of control turn the knob clockwise until the switch clicks and the dial is illuminated.

Turning the volume control knob toward the right increases the output of the receiver and turning it toward the left reduces the output.

Turn the volume control