class="minispace"> 

12-17-71 DR-7086

INSTALLING SERVICE DELCOTRON® GENERATOR

1. DISCONNECT GROUNDED CABLE FROM BATTERY.

2. If it is necessary to rotate the slip ring end frame to match the unit being replaced, remove the thru bolts, separate frames just far enough to rotate to desired position and replace thru bolts.

CAUTION: Separating the end frame too far causes the brushes to drop on to the greased shaft. If this happens, remove end frame completely, clean brushes with clean cloth, reassemble springs and brushes retaining them in position with a pin (toothpick). Remove pin after frames are reassembled.

WHEN INSTALLING DELCOTRON® GENERATOR WITH INTEGRAL REGULATOR, THE SLIP RING END FRAME MOUNTING BRACKET IS NOT NEEDED.

3. When reusing the original fan, pulley and collar, tighten shaft nut to 40 to 60 lb. ft. If torque wrench is not available, insert a 5/16" hex wrench in end of shaft and tighten nut until the spring washer is just flattened.

4. Install Delcotron® Generator and check belt tension, mounting bolt tightness and make sure all electrical connections are clean and secure.

IMPORTANT: Never operate the Delcotron® Generator without being connected to the battery. Never attempt to polarize the Delcotron® Generator.

DELCO-REMY Division of General Motors Anderson, Indiana                   BPI