reverse of Fig. B, Diagram 4). Do not cut off the butt ends, instead straddle the hook as Fig. 2, Diagram 5. Hold between the thumb and finger of the left hand as already explained in Figs. 4 and 10, Diagram 3, page 15. Tip the wings (B) forward so that they stand about perpendicular to the shank, and pull down loop, Fig. 3, as explained in Diagram 3, Fig. 4. Take one more turn with (A) around the wings (B) in front as Fig. 4 and before loosening the grip with the left hand take two turns around the hook close in back of the wings (B), Fig. 5. Next pull the butt ends back tightly as Fig. 6, take two tight turns around them with (A) and cut off on dotted line as Fig. 6. Cross (A) between wings (B) to spread them, and wind tying silk (A) down shank of the hook as Fig. 7.

{28}

Diagram 5

{29}

Fan Wings, Dry Flies and Nymphs tied by the author (actual size)

{30}

From now on the body is made as previously explained, so for the sake of variation we will tie a band in the centre, the same as a Royal Coachman. Tie in tail (C) Fig. 8. Tie in two or three strands of peacock herl (D) Fig. 9 with (A) and wind (A) four or five turns towards the eye of the hook. Take three or four turns with herl (D). Tie in two strands of silk floss (E) Fig. 10, take a few more turns with (A) over the loose ends of (D) towards the eye of the hook. Wind silk floss (E) over the herl about half way up the hook. Take a turn or two around silk floss (E) with (A) and cut off end of (E) as Fig. 11. Carry (A) up to the front of the wings. Finish body with herl (D) wound tight against the back of the wings. (This helps to push the wings forward and to hold them in place.) Tie off herl (D) with (A) Fig. 12. The next step of putting on the hackle (F) is done the same as Fig. 6, Diagram 4, page 21. But here the hackle is much more important than on the wet fly. The floating qualities of a dry fly depend entirely upon stiff neck hackle of the proper size. (Use Hackle Chart.) Sometimes two hackles are used, these are laid together, and both butts tied in at the same time. One hackle of the proper size and stiffness is usually enough, so we will use one tied in as Fig. 13 and explained in Fig. 6, Diagram 4, page 21. Clip the hackle pliers to the tip of hackle (F) and wind about two turns edgewise in front of the wings, wind two turns close {31} in back of the wings. Take two or three more turns in front of the wings, all the while keeping the hackle edgewise, with the shiny side towards the eye of the hook. Wind the hackle close so as not to fill up the eye of the hook and to leave room for the head. Tie in the tip with a couple of turns of (A) Fig. 14. The hackle should now be standing straight out from the hook, with the most of it in front of the wings. Shape a tapered head with (A). (Head should be about 1/16" long on a size 12 hook.) Finish with two or three half hitches and a drop of head lacquer, Fig. 15.

Various feathers are used for wings of dry flies, such as breast feathers from mallard, teal; partridge, grouse, black duck, wood duck. Hackle tips, starling, duck, turkey, goose, pheasant, wing feathers, etc.

Two whole feathers of the proper size, with the natural curve are used for fan wings. The tips of two feathers, or a section may be cut from two matched feathers. All of these wings are tied on in the same manner as previously explained. See Diagram 2 for flies tied with different style wings.

{32}

NYMPHS AND THEIR CONSTRUCTION

NYMPHS

Nymphs are larvae of all aquatic insects. Together with minnows, crawfish, etc., they represent about ninety per cent of the trout's regular diet. Considering this fact, it is obvious that nymphs will take trout throughout the entire season. It will greatly surprise the novice to learn of the great amount of underwater insect life present in any stream. Next time you go fishing, hold your landing net close to the bottom, in a foot or so of fast water. Reach upstream and loosen the stones and gravel. Raise your landing net, and notice the numerous nymphs that have been washed from under the stones, and have attached themselves to your net. Better still, make a screen about two feet square, from regular 14 mesh window screening. Hold this in the water, and have your fishing partner go upstream, and with a regular garden rake, or some such tool, rake up the bottom, turning over the stones and gravel. This way you can capture many nymphs. Put them in glass bottles, take them home, and make copies of them. When next you {33} go fishing open the first trout you catch, examine the contents of its stomach, and determine which of the copies you have made is the proper nymph or fly for the occasion. To fish with an imitation of the fly or nymph upon which they are feeding, will result in a heavier creel.

When nymph fishing it is important to use a long, finely tapered leader. A 4x is about right. Fish in the same waters, and very much the same way as with a dry fly except that the nymph is allowed to sink. Fish upstream, or up and across the current. In the ripples. Around boulders. At the edge of fast water. Let the nymph drift with the current. Follow it with your rod tip, and be prepared to set the hook at the least hesitation of the line. Trout will sometimes take a drifting nymph and eject it, without being felt on the most delicate rod, so be ever on the alert when nymph fishing. A nymph fished down stream, and retrieved with slow, short jerks, will often work very well. When fished in this manner, trout will strike quite hard, and usually hook themselves.

There are times when trout are rolling on the surface and it seems impossible to take them on anything. It is then that they are usually feeding on nymphs, just under the surface. I remember one such time on the Housatonic River in Connecticut last summer. Just at dark, I was standing knee deep in very fast water. Trout {34} were breaking all around me. I knew, they were feeding on nymphs, and tried in every way to catch them. The water was so fast, it was impossible to keep the nymph just the right depth below the surface. I tried every trick that I knew, but could not get a strike. Finally reaching my hand in my pocket, I discovered several large buckshot. Removing the nymph from the tip of the leader, I attached five of these large shots, to the very tip of the leader, with a piece of 3x gut tippet about four inches long. I connected the nymph to the leader about sixteen inches from the tip. Within the next few minutes I took several nice trout, within rod's length of where I was standing. What actually happened, the lead was so heavy that it immediately sank straight to the bottom, and my taut line held the nymph suspended about two inches below the surface. The short gut between the nymph and the leader allowed the nymph to quiver much as the natural was doing. All the various common nymphs can be faithfully copied, by learning to tie the various styles of those herein illustrated. Simply alter the sizes, and color combinations, according to those found in the waters where you fish.

Remember nearly all the nymphs have flat bodies, and dark backs. The bodies may be flattened by thoroughly lacquering them, and when nearly dried squeezing